| 1. | The intake pipe is going to wash them up right inside the water treatment piant
进水管道会将他们冲进水处理厂 |
| 2. | It can be applied simply to diesel engine , because it is unnecessary to change engine ' s configuration . it only needs a set of water injection system of installation before intake pipe of diesel engine
在柴油机上应用该技术非常简单，不需要对柴油机结构做任何改变，只需在进气总管前安装一套喷水系统。 |
| 3. | The utilization of the pressure wave in the intake pipe and exhaust pipe which not only make more exhaust gas out of the cylinder but also improve the charge efficiency and make more fresh gas
合理的利用进、排气管中的压力波，不仅能使更多的废气排出缸外，而且还可以提高发动机的充气效率，使尽可能多的新鲜工质充入。 |
| 4. | The passage dimension of separation chamber , the heating temperature of intake pipe air and the relevant influence of the ceramic heat insulation coating of combustion chamber upon the compressive ignition process of natural gas were studied by experiment
实验研究了分隔室通道尺寸、进气管空气加热温度、燃烧室陶瓷隔热涂层对天然气压燃着火过程的相关影响。 |
| 5. | The intake lag angle of the engine is optimized , and the dynamic effects of intake pipes and exhaust pipes to the improvement of motorcycle engine is applied to make the engine test performance curve approach the simulation curve
本文介绍了从进气晚关角及进排气的动态效应几方面着手，不断改进发动机的配气相位以及进排气系统，使发动机的实际性能曲线逐步接近计算机仿真曲线。 |
| 6. | Exhaust system can be respectively calculated in two - stroke and four - stroke engines by the developed escs system for application . it can also analyze the pressure wave in the intake pipe and exhaust pipe which infect on engine dynamical performance
应用开发出的escs系统分别对二冲程发动机及四冲程发动机的排气净化系统进行模拟计算，分析进、排气管中压力波对发动机动力性能的影响。 |
| 7. | For intake system , adopting the resonant intake manifold construction , make use of the intake motive effect to increase volumetric efficiency ; adopt measure to prevent the heat transmit between intake pipe and exhaust pipe , lower the intake air temperature to increase volumetric efficiency
对于进气系统，采取谐振进气的结构措施，利用进气动力效应来提高进气充量；采取进、排气管隔热措施，降低进气温度来提高进气充量。 |
| 8. | For the sake of realizing compressive ignition of single fueled natural gas and aiming at the characteristics of high spontaneous combustion temperature of natural gas , the separated combustion chamber provided with low heat radiation structure was designed , meanwhile the heating device for the intake pipe air and the ceramic electro - thermal plug heating device inside the separation chamber were set up
摘要为实现单一燃料天然气的压燃着火，针对天然气自燃温度高的特点，设计了具有低散热结构的分隔式燃烧室，同时设置了进气管空气加热装置和分隔室内陶瓷电热塞加热装置。 |
| 9. | In this paper , a matching platform for a model lh150 four stroke motorcycle engine is set up and a electronic fuel injection system is designed . the design of the electronic fuel injection system include the fuel supply system design , the intake pipe and throttle body design , the electronic control unit ( ecu ) develop , the way to use sensor of the system and the means to deal with sensor signal
本论文建立了一套针对lh150型四冲程摩托车发动机的匹配台架，设计了一套用于摩托车发动机的电控燃油喷射系统，对发动机供油系统、进气系统进行了设计和选配；建立了一套传感器的使用和信号处理方法；设计了一套电控单元硬件，并初步确定了电控单元的控制方法。 |
